Blog - MG Distributor

August 12, 2026

Spending hours cut-and-buffing heavy orange peel eats away at your shop’s cycle times and profitability. While color sanding has its

August 11, 2026

Peeling paint on plastic bumpers is one of the most common—and expensive—body shop warranty comebacks. Unlike traditional steel or aluminum

August 10, 2026

A basic air line filter might stop rusty pipe scale and heavy water sloshing out of your compressor, but it

August 7, 2026

Spraying silvers, champagne greys, and three-stage pearl basecoats is widely considered the ultimate test of a refinish technician’s skill. Few

August 6, 2026

From standard heavy-duty aluminum gravity cups to non-stick black ceramic coatings, the interior surface of your paint reservoir impacts cleaning

August 5, 2026

You can buy a top-tier HVLP spray gun, but if your air compressor only pushes 8 CFM and your gun

August 4, 2026

Before laying a single drop of clearcoat onto a customer panel, always spray a quick test pattern onto masking paper.

August 3, 2026

Setting your wall compressor regulator to 30 PSI does not mean 30 PSI is actually reaching your air cap when

July 31, 2026

Soaking an entire spray gun inside a bucket of lacquer thinner might seem like the fastest way to wash out

July 30, 2026

A professional spray gun isn’t just a spray nozzle attached to a paint cup—it is a high-precision fluid-aerodynamic engine. When

Industry Insight